IVMS 4200 FOR MAC FOR MAC
IVMS 4200 FOR MAC FULL

Due to the many revisions, we recommend that the user closely follows the instructions below in order to reduce the amount of time spent as well as the chance of failure.Īs more affordable IP cameras are introduced over time with greater video resolution and data sizes, more efficient database management also becomes necessary. The introduction of firmware v4.0 brought about a new database architecture in order to be futureproof.Īfter upgrading to v4.X, the recorder database will need to be converted and optimized. All recorders must reach v3.4.92 before proceeding further.Upgrading from v3.4.92 build 170518 or Older If you are experiencing issues where playback is expected but not found, make sure 'Database Repair' is performed as indicated in the procedures and scenarios below.īefore proceeding with upgrade, it is recommended that NVR configuration file is exported from the NVR over the network or on to a local USB drive.

IVMS 4200 FOR MAC FULL

If the recorder is already at v3.4.92, a full factory default is highly recommended before upgrading to any version of v4.X.Upgrading from versions before v3.4.92 directly to any version of v4.X will likely cause the recorder to fail.

IVMS 4200 FOR MAC FOR MAC

#IVMS 4200 FOR MAC CATALINA FULL#Īfter reaching v3.4.92 and performing a full factory default, an upgrade directly to v4.50.00 is acceptable.There is a high chance of unit failure (requiring RMA) if the unit is not defaulted before upgrade. #IVMS 4200 FOR MAC CATALINA UPGRADE#Īfter the upgrade is completed and the recorder is reprogrammed, it may be beneficial to perform a Database Repair. To verify repair progress, you may refer to the HDD status, or search the recorder log for repair started and stopped entries.įor details, refer to the section 'Database Optimization and Repair' above.Note that while the HDD is repairing, new recordings are still being made, but some existing recordings may not be searchable until repair is complete. If you continue to observe playback issues after database repair, ensure there are no power, network, or motion detection issues.

Should the problem persist, contact technical support. Upgrading from Any v4.X Build to v4.50.00.

Any v4.X build can be upgraded directly to v4.50.00.

Export configuration is highly recommended before performing the upgrade.

If upgrading from any v4.X version that was not v4.22.005, a Database Repair is recommended.

Ivms 4200 for mac